Not logged in - Login
< back

Renard Serial to RF Transmitter - Removed

Note these instructions are good for Beta 1 Release only

Hardware Serial Modification - Do this modification before getting started

How To Program the Serial to RF Transmitter

  1. Open the IDE
  2. In the RFPixelControl\examples folder find the RenardInterrupt Transmitter
    Open the Transmitter Sketch
  3. There are some changes you will need to make to set up the transmitter
    Edit Configuration Options

  1. First Choose what RF Channel you want this transmitter to use, If you only have 1 use 100 its a pretty good one.

#define RF_NUM_PACKETSTRANSMIT_CHANNEL 18     //100

  1. Next 18Choose *which 30Serial totalBaud ChannelsRate canto transmit with

#define RENARD_SERIAL_BAUD       57600

  1. Next Choose a Unique ID For this device, This number needs to be broadcasteddifferent on each of your RF devices

#define TRANSMIT_CHANNEL 100
#define RENARD_SERIAL_BAUD       57600
#define   RECEIVER_UNIQUE_ID 0

  1. Next Choose what hardware you are using. This is so you have the right pin setup for your transceiver

#define  NRF_TYPE                     RF1_1_3

  1. Next NRF_TYPE                     RF1_1_3Choose the Data Rate that the RF Transceiver is going to use

#define PIXEL_TYPE                     NONE
#define   DATA_RATE RF24_1MBPS